Ranger/ Raptor & Everest Key Fob Programming

Ford Ranger & Raptor key fob programming.

To start, the vehicle must be unlocked with the doors closed and handbrake off!

Insert your original key into the centre console backup slot (as shown in image). The Everest has a mat that covers this. You will need to remove the rubber mat, then you will see the slot.
Turn the ignition on for 5 seconds, but no more than 10 seconds.
Turn the ignition off and remove the key from the centre console slot.
Within 10 seconds of turning off the ignition, insert your second original key in the centre console slot.
Repeating step 2, turn the ignition on for 5 seconds, but no more than 10seconds
Turn the ignition off and remove the second key.
Between 3 seconds and 10 seconds of turning the ignition off, remove thepreviously coded key and insert your NEW unprogrammed key.
Turn the ignition from off to on ONCE . Keep the ignition on for at least six seconds. (if successful the indicators should flash)
Remove the newly programmed coded key.
If the new key FOB has been successfully programmed, it will start the vehicle’s engine by pressing the lock button ONCE, followed by a double press of the Start button on the FOB.
If unsuccessful, repeat steps 1 through to 9.

Please take note of the following information

To remote start the vehicle, press LOCK once then the 2x Start Button TWICE.

If you have our Stop/Start Eliminator installed and use the key FOB for remote starting, the eliminator will not automatically deactivate the stop/start function. This is because the remote start feature disables certain functions that the eliminator relies on to reverse the signal to the switch.
The fourth button, which is the Boot release, will function correctly with factory-installed roller covers on Ranger Raptor and Wildtrak models.
After two remote start events, it is necessary to drive your vehicle. If you attempt to remote start the car more than twice without driving it, the remote start function will not activate.